Epson Stylus Pro 9000 - Print Engine Service Manual page 161

EPSON Stylus Pro 9000
For paper meeting the following requirements, only the feeding
operation is guaranteed:
Weight 17 to 24 lb (64 to 90 gf/m
Quality Normal, recycled paper (load short edge first portrait)
Environment 59 to 77 °F (15 to 25 °C) / 40 to 60% humidity
The printer exerts between 300 to 500 gf to peel off the rear edge of
roll paper from the core
Paper feeding is normal until the rear edge of the paper separates
from the core. At the point where the rear edge is free, print quality
is not guaranteed.
Upper spindle last 15.75 inches (400 mm) not guaranteed
Lower spindle last 11.8 inches (300 mm) not guaranteed
Table 7-2. Printable Area for Roll Paper and Single Sheets
Heading Roll Paper
Paper width 7.2 to 44 in.
(182 to 1,118 mm)
Paper length 8.27 to 771.65 in.
(720 to 4,500 mm)
Left margin 0.12 to 0.59 in.
(3 or 15 mm*)
Top margin 0.12 to 0.59 in.
(3 or 15 mm*)
Right margin 0.12 to 0.59 in.
(3 or 15 mm*)
Bottom margin 0.12 to 0.59 in.
(3 or 15 mm*)
* The size of the margin is determined by the control panel setting.
Appendix
2
)
Single Sheets
8.27 to 44.02 in.
(297 to 1,118 mm)
16.54 to 62.2 in.
(420 to 1,580 mm)
0.12 in. (3 mm)
0.12 in. (3 mm)
0.12 in. (3 mm)
0.55 in. (14 mm)
LM
Paper
Figure 7-3. Printable Area for Single Sheets

Roll paper
Width 8.27 to 44.02 in. (210 to 1,118 mm)
Length 28.35 to 1,771.65 in. (720 to 4,500 mm
(2-inch roll: 3.9 in. (100 mm or less) /
3-inch roll: 5.9 in. (150 mm or less)
Thickness 0.0026 to 0.019 in. (0.065 to 0.5 mm)
PW
RM
T
Printable
PL
B
161