Control Panel Operations; Control Panel Buttons; Operation In Normal Mode - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000

1.2 Control Panel Operations

The EPSON Stylus Pro 9000 control panel displays status and error
messages, and the lights indicate when a problem occurs or if any ink
cartridge is low or runs out. This section provides information on the
control panel buttons, LEDs, and liquid crystal display (LCD).
Operate Pause
Reset
3 sec.
Ink Out
K C M LC LM
Paper Out
SelecType
Paper Source
Roll
Auto Cut
Item
Roll
+
Cutter Off
Paper Feed
Sheet
_
Cut /Eject
Enter
Cleaning
Power
3 sec.
Figure 1-2. EPSON Stylus Pro 9000 Control Panel
Printer Basics
Y
LCD Display

1.2.1 Control Panel Buttons

Pressing a control panel button executes the functions listed in
Table 1-1 and Table 1-2.

1.2.1.1 Operation in Normal Mode

Table 1-1. Operation in Normal Mode
Button (Second function)
Power
Pause (Reset)
SelecType
Cut/Eject (Enter)*
Paper Feed U
Paper Feed D
Paper Source (Item)
Cleaning
* Interrupts the ink-drying time, if taking place.
** 1.27 cm/second paper feed for 2 seconds after key is pressed.
7.62 cm/second paper feed if pressed for over 2 seconds.
Maximum feed of 20 cm when the button is pressed once.
*** 1.27 cm/second paper feed for 2 seconds after key is pressed.
7.62 cm/second paper feed if pressed for over 2 seconds.
Function
Power ON and OFF
Switches between online and offline.
Resets the printer if pressed for 3 seconds.
Enters SelecType mode (when printer is in
Standby)
• Cuts and ejects paper if Roll Auto Cut is
selected
• Ejects paper if Roll Cutter Off or Sheet is
selected
Feeds paper backward**
Feeds paper forward***
Selects paper source:
• Roll Auto Cut
• Roll Cutter Off
• Sheet
Cleans both heads if pressed for 3 seconds
12