Front Cover Removal - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000

FRONT COVER REMOVAL

Preparation:

Remove the Maintenance Cover as described in
Removal on page 58.

Remove the Top Cover as described in

Remove the Left and Right Side Covers as described in
Side Cover Removal on page 60.
1. Remove the two screws (CP(W2) M3x8) securing the damper assembly on
the left side of the printer, and then remove the damper assembly.
Figure 4-8. Removing the Damper Assembly
Disassembly & Assembly
Maintenance Cover
Top Cover Removal on page 59.
Left and Right
Damper Assembly
2. The Front Cover Assembly hinges on a mounting pin at each end. Remove
the four screws securing the mounting pins as shown below.
Left side
Right side
Figure 4-9. Locations of Front Cover Shaft Screws
When removing the Front Cover, avoid tilting it down to the
left. The little wheels mounted on the cover's shaft are not
secured and may slide off.
3. While supporting the Front Cover, pull out the mounting pins, and then
remove the Front Cover from the printer.
CP(W2) M3x8 screws
61