Simple Batch - A&D AD-4405 Instruction Manual

F22 = 9 (Check weighing 3:Loss in weight) F22 = 9 (Check weighing 3:Loss in weight) F22 = 9 (Check weighing 3:Loss in weight) F22 = 9 (Check weighing 3:Loss in weight)
Output and Condition Output and Condition
Output and Condition Output and Condition
Relay HI,
Relay LO,
Relay OK*,
* Relay OK output can be changed to OVER or UNDER by setting f24.
Triangle
OVER/UNDER is judged always and the result is output to the LED and the relay.
10.2.2.

Simple Batch

The weighing sequences of simple batch (f22 10, 11 or 12) are similar to those of
Check weighing (f22 7, 8 or 9) respectively. The differences are listed below.
1 Basically ON/OFF of the relay and the LED are reversed.
2 No judgment other than Zero band and Full before input of the Start signal.
3 The weighing completion condition is set by f23 2x and it is effective after Start.
4 The outputs of Preliminary and Free fall are off from weighing completion to the
next start.
5 Weighing completion can be output by setting f24 and f25.
6 The start signal can be accepted after weighing completion even if the weight is
not within the zero band.
7 Over/Under output is set by f23 3x.
Start Start Start Start
Tare, when the Start is input automatically if f23 11.
The READY mark turns off when the Start is input.
Weighing Completion Weighing Completion
Weighing Completion Weighing Completion
The weighing completion condition is set by f23 2x.
f23 20 : Either the STOP key is pressed or the Batch stop input is on.
f23 21 : Stable is detected after reaching Final.
Before reaching Final, the
completion even if f23 21.
10.2. Setpoint Comparison
Weighing value
Calibrated Zero
]
1, -Net - (Final - Free fall)
3, Gross ¢ Zero band
]
2, Gross Full
2 is displayed when Gross ] Full regardless of the f24 setting.
Tared Zero
Weighing
Free fall
OFF
ON
OFF
ON
OFF
key or Batch stop input forces weighing
STOP
Page 42
Preset target weight
Final Tare
ON
ON
OFF
AD-4405 Weighing Indicator
Zero band
Time
OFF
OFF
ON