Rear Panel Description; Other Displays And Symbols - A&D AD-4405 Instruction Manual

ZERO key
CLEAR key
TARE key
ESC key
NET/GROSS key
+/- key
ENTER key
PRINT key
ON/OFF key
10 Printer cover
Printer
4.1.2.

Rear Panel Description

11
No. Name
11 Power cable
12 Grounding terminal
13 Load cell connector
14 CAL switch cover
15 Sealing panel
16 RS-232C connector
4.1.3.

Other Displays and Symbols

AD-4405 Weighing Indicator
The key to zero the current display.
The key to clear the setting value.
The key to perform tare.
The key to proceed to the next step without changing the
parameter set.
The key to select net or gross weight in the display.
The key to select + or – of a value.
Confirms settings and stores the value.
The key to print/output data (press and release quickly).
Turns the indicator on and off (OFF: hold for 3 seconds).
Printing paper will be stored inside when the printer is installed.
Internal dot matrix printer (optional).
12
Please confirm that the local voltage and receptacle type are
correct for your scale.
Connect to the Earth (M4 size screw).
Connect a load cell using the accessory load cell plug.
The CAL switch is located behind the sealing panel [15].
For type approval, available with the sealing wire posts.
Exchange this when installing other data output (options).
Standby display.
Zero error when turning the display on. If the
pressed, the current weighing value may should be displayed.
Over load display. Remove any load from the load cell
immediately. It may cause damage to the load cell.
An example of an error display.
Page 9
13 14
15
16
Description
4. Description of Panels and symbols
key is
ESC