Gravity Compensation Function - A&D AD-4405 Instruction Manual

5.5. 5.5.

5.5. Gravity Compensation Function

5.5.
If the scale is used at the calibration location, it is not necessary to perform this function.
If there is a difference of gravity acceleration between the installed location and
calibration location it may cause a weighing error. This function specifies the
gravity accelerations and corrects the span error.
Note The decimal point is not displayed in the function. Example: 9798 = 9.798 m/s
When span calibration is executed, the gravity acceleration correction will
be cleared and the two gravity acceleration values will return to the factory
settings.
Step 1 At the Cal 0 display, press the
ENTER
If you want to cancel the current procedure, press and hold the
the
ESC
Press the
Step 2 The parameter is displayed with triangle 1. Enter the gravity acceleration of the
calibration location using the
acceleration.
ENTER
key .......The key to return to g 5et without changing the value.
ESC
Step 3 The parameter is displayed with triangle 2. Enter the gravity acceleration of the
installed location using the
ENTER
key .......The key to return to step 2 without changing the value.
ESC
Step 4 Now g xxxx is displayed. Press the
displayed. Proceed to step5.
Caloff could be displayed by pressing the
instead of the CAL key.
Step 5 Press the
AD-4405 Weighing Indicator
Gravity Compensation Function Gravity Compensation Function Gravity Compensation Function
key to enter the gravity compensation function.
key. Then, no parameters are changed and the calibration mode is finished.
key to turn the display off after displaying CanCel.
ON/OFF
key...The key to store the new gravity acceleration and proceed to step 3.
0
key...The key to store the new gravity acceleration and proceed to step 4.
key to turn the display off.
ON/OFF
key twice, g 5et is displayed and press the
MODE
- keys. The parameter xxxx is the gravity
0 9
- keys. The parameter xxxx is the gravity acceleration.
9
key to store the parameters. Caloff is
CAL
key while pressing the
+/-
Page 19
key and press
ON/OFF
ON/OFF
5.5. Gravity Compensation Function
2
key