Announcement - AT&T EL52309 - DECT 6.0 User Manual

Handset settings
Answering system settings

Announcement

Outgoing announcements are the messages callers hear when calls are
answered by the answering system.
The telephone has a prerecorded outgoing announcement, "Hello. Please
leave a message after the tone." You can use this announcement, or record
your own announcement.
You can record an announcement up to 90 seconds. The system does not
record any announcement shorter than one second.
To play your current outgoing announcement:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press /SELECT again.
MENU
3. Press CID or DIR
press /SELECT.
MENU
4. Press CID or DIR
press /SELECT, the system announces, "To play, press
MENU
2. To record, press 7."
5. Press 2 to play the current announcement.
To record a new outgoing announcement:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press /SELECT again.
MENU
3. Press CID or DIR
press /SELECT.
MENU
4. Press CID or DIR
press /SELECT, the system announces, "To play, press
MENU
2. To record, press 7."
5. Press 7 to record an announcement, the system announces
"Record after the tone, press 5 when you are done."
6. Press 5 when you finish the recording. Your recorded
announcement plays.
To listen to the recorded announcement again, press 2 after playback is
completed.
To record a new announcement, press 7 and follow step 6.
NOTE: If the answering system is full and you want to record a new announcement,
the system announces, "Memory is full." You must delete some messages before
you can record a new announcement.
to scroll to >ANS SYS SETUP, then
to scroll to >ANNOUNCEMENT, then
to scroll to >ANS SYS SETUP, then
to scroll to >ANNOUNCEMENT, then
15
to
?BOT/!TZTUFN
SELECT
EJSFDUPSZ
?BOT!TZT!TFUVQ
QMBZ!NTHT
?BOOPVODFNFOU
$!PG!SJOHT
to
SELECT
3.QMBZ!4.EFMFUF
6.TUPQ!8.SFDPSE
SFDPSE!BOOD///
6.TUPQ