Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change to wall-
mounting, see Installation options on page 13 for details.
Telephone base installation
Plug the large end of the telephone
f
base power adapter into a power
outlet not controlled by a wall
switch.
Route the power
f
adapter cord
through this slot.
Raise the antenna.
f
Charger installation
Plug the power adapter into a power
outlet not controlled by a wall switch.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this
product. To order a replacement power adapter,
visit our website at
https://telephones.att.com
1 (800) 222-3111
1 (866) 288-4268
2. The power adapters are intended to be correctly
oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
8
Plug the other end
f
of the telephone
line cord into a
telephone jack or a
DSL filter.
If you have DSL
high-speed Internet
service, a DSL filter (not
included) is required.
The DSL filter must
be plugged into the
telephone wall jack.
Telephone line cord
Plug one end of the
f
telephone line cord
into the telephone
jack on the back of
the telephone base.
Plug the small end of the
f
telephone base power adapter
into the power adapter jack on
the back of the telephone base.
. In Canada, dial
.
or call