Table of Contents
Advertisement
Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change to
wall-mounting, see Installation options on page 18 for details.
Telephone base installation
Plug the large end of the
telephone base power adapter
into a power outlet not
controlled by a wall switch.
Route the power
adapter cord through
this slot.
Plug the small end of the
telephone base power adapter
into the power adapter jack on
the back of the telephone base.
Plug the other end of the telephone
line cord into the telephone jack on
the back of the telephone base.
13
Plug one end of the
telephone line cord into a
telephone jack or a DSL filter.
If you have DSL
high-speed Internet
service, a DSL filter
(not included) is
required.
Route the
telephone line cord
through this slot.
Raise the antenna.
Advertisement
Table of Contents
