Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change
to wall-mounting, see Installation options on page 18 for
details.
Telephone base installation
Route the telephone line
cord through this slot.
Plug the other end of
the telephone line cord
into the telephone
jack on the back of the
telephone base.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Raise the antenna.
Plug one end of the telephone
line cord into a telephone jack
or a DSL filter.
Plug the small end of the
telephone base power
adapter into the power
adapter jack on the back
of the telephone base.
11
Plug the large end
of the telephone
base power
adapter into a
power outlet not
controlled by a
wall switch.
Route the power
adapter cord through
this slot.