Telephone Base And Charger Installation; Telephone Base Installation - AT&T CLP99283 User Manual

Getting started

Telephone base and charger installation

Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change to
wall-mounting, see Installation options on page 14 for details.

Telephone base installation

Plug the large end of the
telephone base power
adapter into a power
outlet not controlled by a
wall switch.
Route the power adapter
cord through this slot.
Raise the antenna.
Plug the small end of the
telephone base power
adapter into the power
adapter jack on the back
of the telephone base.
9
Plug one end of the
telephone line cord into a
telephone jack or a DSL filter.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Route the telephone line
cord through this slot.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.