Table of Contents
Advertisement
Advanced Configuration
Expert Level - SNMP Trap Receiver section fields
Sets the IPs to receive the trap alerts from the unit.
Expert Level - Remote Access IP Range section fields
The Symantec Firewall/VPN's web interface can be accessed remotely from a range of IP
addresses. For security reasons, Symantec recommends that all external remote management be
done through a VPN tunnel. When using a VPN tunnel, simply point your growser to the internal
IP address of the Symantec Firewall/VPN.
To remotely configure the unit, enter the start and end IP range (enter the same value for both if it's
a single IP). You can then access the unit from an external web browser by entering the WAN port
IP followed by port 8088.
For example: type "http://207.158.227.235:8088" into your external browser if 207.158.227.235
was the address obtained from your ISP by the Symantec Firewall/VPN. You must be accessing
from the IP range specified. Also, you should set the Configuration Password for security.
Allow Remote Upgrade
You can Enable Allow Remote Upgrade if you wish to remotely perform TFTP upgrades to the
unit's firmware from the above IP range. The default is Disabled.
4-28
Hide quick links:
Advertisement
Table of Contents
