Firmware Upgrades
To upgrade firmware
1.
Power off the unit by pulling the adapter plug from the back of the Firewall/VPN.
2.
Flip DIP switch 1 & 2 to the ON position (DOWN)
3.
Put the power plug back into the Symantec Firewall/VPN.
4.
Open up a DOS prompt by clicking Start then Run... Type command and click OK.
5.
CD to your temp folder with the firmware and nxtftp command.
6.
Type nxtftp 192.168.0.1 PUT <firmware name> and press Enter.
7.
After a few moments you should see a "success" message... If not, reboot your computer
and try again.
8.
Return the DIP switches to their normal positions.
10-2