Viewing Your System Configuration - Cisco 7206VXR - VPN Bundle Router Configuration Manual

Viewing Your System Configuration

Viewing Your System Configuration
You can use the show version and the show diag commands to view information specific to the hardware
configuration of your Cisco 7200 VXR router.
Use the show version (or show hardware) command to display the system hardware (the network
processing engine or network services engine and the number of interfaces installed), the software
version, the names and sources of configuration files, and the boot images.
The following sample output of the show version command shows an NPE-G1 installed in the
Cisco 7206VXR.
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-JS-M), Released Version 12.2(20011220:181136) [biff dec21
101]
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Fri 21-Dec-01 05:58 by
Image text-base:0x600089B8, data-base:0x6196E000
(sample text omitted)
term1_500 uptime is 1 day, 19 hours, 25 minutes
System returned to ROM by reload at 00:04:18 UTC Tue Nov 30 1999
System image file is "disk2:c7200-js-mz.dev-test.dec21"
cisco 7206VXR (NPE-G1) processor (revision 0x00) with 245760K/16384K bytes of memory.
Processor board ID 13250983
BCM12500 CPU at 700Mhz, Implementation 1, Rev 0.1, 512KB L2 Cache
6 slot VXR midplane, Version 2.0
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
5 FastEthernet/IEEE 802.3 interface(s)
3 Gigabit Ethernet/IEEE 802.3 interface(s)
509K bytes of non-volatile configuration memory.
62528K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes).
16384K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0
Use the show diag command to determine what type of port adapters and I/O controller (with or without
the Fast Ethernet port) are installed in slot 0 through slot 4 of your Cisco 7204VXR or slot 0 through
slot 6 of your Cisco 7206VXR. You can also use the show diag slot command to display information
about a specific port adapter slot.
The following example shows the show diag command output from a Cisco 7206VXR with an NPE-G1
installed.
Router# show diag
Slot 0:
Cisco 7200 VXR Installation and Configuration Guide
4-20
Dual FastEthernet (RJ-45) I/O Card Port adapter, 2 ports
Port adapter is analyzed
Port adapter insertion time 1d19h ago
EEPROM contents at hardware discovery:
Hardware Revision
Board Revision
Connector Type
Chapter 4 Observing System Startup and Performing a Basic Configuration
:0.0
:01
:FF
OL-5013-09