Npe-G2 Leds - Cisco 7206VXR - VPN Bundle Router Configuration Manual

Chapter 1 Cisco 7200 VXR Product Overview
or not an I/O controller is in the system with the NPE-G1 or NPE-G2. The SLOT ACTIVE LED is on if
there is a CompactFlash Disk in the NPE-G1. The CF ACTV LED is on if there is a CompactFlash Disk
in the NPE-G2.
To prevent system errors and problems, use the CPU reset button only at the direction of your service
Caution
representative.
Table 1-24
lists LEDs on the NPE-G2.
Note LEDs are either on or off. The LED state (on or off), not the color, determines the status of connection.
However, most LEDs are green when on, with the exception of the IO POWER OK LED, which is amber
when in the on state. However, with the introduction of the NPE-G2, flashing LEDs are also indicative
of activity.
Table 1-24
LED
ENABLED
IO POWER
OK
Slot 0
Slot 1

NPE-G2 LEDs

Table 1-25
LED Label
LINK ACTV
(Interfaces 0/1, 0/2,
0/3)
EN (Enable)
(Interfaces 0/1, 0/2,
0/3)
FE LINK
OL-5013-09
lists LEDs common to all models of I/O controllers and describes their functions.
Figure 1-21
I/O Controller LEDs
Color Function
Green Indicates that the network processing engine or network services engine
and the I/O controller are enabled for operation by the system; however, it
does not mean that the Fast Ethernet port on the I/O controller is functional
or enabled. This LED goes on during a successful router boot and remains
on during normal operation of the router.
Amber Indicates that the I/O controller is on and receiving DC power from the
router midplane. This LED comes on during a successful router boot and
remains on during normal operation of the router.
Green These LEDs indicate which PC Card slot is in use by coming on when
either slot is being accessed by the system. These LEDs remain off during
normal operation of the router.
NPE-G2 LEDs
LED
RJ-45 and SFP
ports
RJ-45 ports only
Fast Ethernet
Management port
lists the LEDs on the NPE-G1.
Color
Solid green
Flashing green
Off
Solid green
Off
Solid green
Flashing green
Off
Cisco 7200 VXR Installation and Configuration Guide
Field-Replaceable Units
Status in the Power Up State
Link with no activity.
Link with activity.
No link.
RJ-45 port is selected.
SFP port is selected.
Link with no activity.
Link with activity.
No link.
Table 1-25
1-41