Db-25 Port Cabling And Pinouts - Cisco 7206VXR - VPN Bundle Router Configuration Manual

Chapter 3 Installing a Cisco 7200 VXR Router
Note Both the console and the auxiliary ports are asynchronous serial ports; any devices connected to these
ports must be capable of asynchronous transmission. (Asynchronous is the most common type of serial
device; for example, most modems are asynchronous devices.)
The I/O controller uses two types of physical media for console port and auxiliary port connections.
Table 3-13
The NPE-G1 and NPE-G2 use RJ-45 media for console port and auxiliary port connections. See
Table 3-18
Table 3-13
Model
C7200-I/O-GE+E
C7200-I/O-2FE/E
C7200-I/O-FE
C7200-I/O
C7200-I/O-FE-MII
Before connecting a terminal to the console port, configure the terminal to match the router console port
as follows: 9600 baud, 8 data bits, no parity, 2 stop bits (9600 8N2). After you establish normal router
operation, you can disconnect the terminal.

DB-25 Port Cabling and Pinouts

The DB-25 ports and connectors conform to the EIA/TIA-232 serial data transfer standard for
communications between DTE and DCE equipment.
connections for DB-25 physical media.
OL-5013-09
describes the I/O controller console and auxiliary port media type for each model.
for console port pinout information and
Console and Auxiliary Port Physical Media
Console Port
RJ-45 port
RJ-45 port
DB-25 port
DB-25 port
DB-25 port
Connecting I/O Controller, NPE-G1, or NPE-G2 Cables
Table 3-19 for auxiliary port pinout information.
Auxiliary Port
RJ-45 port
RJ-45 port
DB-25 connector
DB-25 connector
DB-25 connector
Figure 3-28 shows console and auxiliary port
Cisco 7200 VXR Installation and Configuration Guide
3-35