Connecting Power - Cisco 7206VXR - VPN Bundle Router Configuration Manual

Chapter 3 Installing a Cisco 7200 VXR Router
Table 3-19
Pin
5
6
3
7
8
1. Any pin not referenced is not connected.
2. RING is not supported on Cisco-supplied adapters. To use this pin, you must create a customized
3. Pin 7 can be used as a DCD input for connection to a modem. The RJ-45-to-DB-25F adapter maps
When connecting to an auxiliary port on a Cisco 7200 VXR router, the port will not function at baud
Note
rates higher than 19.2k. If the baud rate on the connecting device is set higher than 19.2k, either garbled
text or nothing will be displayed on the screen

Connecting Power

This section provides the procedures for connecting AC-input and DC-input power to your Cisco 7200
VXR router.
This unit might have more than one power cord. To reduce the risk of electric shock, disconnect the
Warning
two power supply cords before servicing the unit. Statement 14
Note Detailed instructions for handling and replacing the Cisco 7200 VXR power supplies are contained in
the 280-Watt AC Power Supply Replacement Instructions and 280-Watt DC-Input Power Supply
Replacement Instructions documents. These documents are available on the Documentation DVD and
on Cisco.com.
The AC power supply has double pole/neutral fusing. Statement 188
Warning
OL-5013-09
Auxiliary Port Signals for NPE-G2, NPE-G1 and C7200-I/O-2FE/E and C7200-I/O-GE+E
(continued)
1
Signal Direction
GND —
RXD In
DSR/DCD In
(RLSD)
CTS In
cable.
DCD to this pin when the adapter is used with a straight-through cable. (See
Description
Signal Ground
Receive Data
Data Set Ready/Data Carrier Detect
(Receive Line Signal Detect)
Clear To Send
Table
Cisco 7200 VXR Installation and Configuration Guide
Connecting Power
3-16.)
3-41