Saving The Running Configuration To Nvram; Checking The Running Configuration Settings; Viewing Your System Configuration - Cisco CISCO7206 Quick Start Manual

Cisco systems router quick start guide

Hide thumbs Also See for CISCO7206:

Table of Contents

end

Use this configuration? [yes/no]: yes

[OK]

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started!

Your Cisco 7206 router is now minimally configured and ready to use. You can use the setup command if you want to modify

the parameters after the initial configuration. To perform more complex configurations, use the configure command.

For information on additional interface configuration and specific system configurations, refer to the modular configuration

and modular command reference publications in the Cisco IOS software configuration documentation set that corresponds to

the software release installed on your Cisco hardware. See Page 1 for documentation URLs.

Saving the Running Configuration to NVRAM

To store the configuration or changes to your startup configuration in NVRAM, enter the copy running-config startup-config

command at the

prompt:

Router#

Router# copy running-config startup-config

Using this command saves the configuration settings that you created in the router using configuration mode and the setup

facility. If you fail to do this, your configuration will be lost the next time you reload the router.

To check the value of the settings you have entered, enter the show running-config command at the

prompt:

Router#

Router# show running-config

To review changes you make to the configuration, use the EXEC mode show startup-config command to display the information

stored in NVRAM.

You can use the show version (or show hardware) and the show diag commands to display the system hardware (the network

processing engine and the number of interfaces installed), the software version, the names and sources of configuration files,

and the boot images. Use the show diag command to determine what type of port adapters and I/O controller are installed.

For specific information on the show version, show diag, and other commands, refer to the modular configuration and modular

command reference publications in the Cisco IOS software configuration documentation set that corresponds to the software

release installed on your Cisco hardware.

Table of Contents