Cisco 7206VXR - VPN Bundle Router Configuration Manual page 136

Connecting I/O Controller, NPE-G1, or NPE-G2 Cables
The Cisco 7200 VXR routers ship with a roll-over cable. Connection to a terminal or a modem will
require an RJ-45-to-DB-25 adapter, and possibly a DB-25-to-DB9 adapter. Refer to
cable and adapter configurations that can be used to connect terminals and modems to the Cisco 7200
VXR routers.
Table 3-17
Access Server Port
Console or auxiliary
Console or auxiliary
Console or auxiliary
1. The FDTE RJ-45-to-DB-25 adapter is labeled "Terminal".
2. The MMOD RJ-45-to-DB-25 adapter is labeled "Modem".
RJ-45 Console Port Signals and Pinouts
The NPE-G1, NPE-G2, and the C7200-I/O-2FE/E and C7200-I/O-GE+E I/O controllers do not support
Data Carrier Detect (DCD).
and the C7200-I/O-2FE/E and C7200-I/O-GE+E I/O controllers.
Table 3-18
Pin
1
2
3
4
6
7
8
1. Any pin not referenced is not connected.
RJ-45 Auxiliary Port Signals and Pinouts for the NPE-G2, NPE-G1 and I/O Controllers
Table 3-19
controllers and NPE-G1, and NPE-G2
Table 3-19
Pin
1
2
3
2
4
Cisco 7200 VXR Installation and Configuration Guide
3-40
Asynchronous Device Cabling Options
RJ-45 Cable Type
Roll-over
Straight
Roll-over
Table 3-18
Console Port Signals for NPE-G1, NPE-G2, and C7200-I/O-2FE/E and
C7200-I/O-GE+E
1
Signal Direction
CTS Out
DSR Out
RXD Out
GND —
TXD In
DTR In
RTS In
lists the RJ-45 auxiliary port signals for the C7200-I/O-2FE/E and C7200-I/O-GE+E I/O
Auxiliary Port Signals for NPE-G2, NPE-G1 and C7200-I/O-2FE/E and C7200-I/O-GE+E
1
Signal Direction
RTS Out
DTR Out
TXD Out
RING In
Chapter 3
DB-25 Adapter
1
FDTE
FDCE
2
MMOD
lists the RJ-45 console port signals for the NPE-G1, NPE-G2,
Description
Clear To Send (tracks RTS)
Data Set Ready (always on)
Receive Data
Ground
Transmit Data
Data Terminal Ready
Ready To Send
Description
Ready To Send
Data Terminal Ready
Transmit Data
Ring Indication
Installing a Cisco 7200 VXR Router
Table 3-17 for the
End Device
Terminal
Terminal
Modem
OL-5013-09