Table 55. Chassis Id Leds; Table 56. Fault/Status Led - Intel SE7525GP2 Technical Manual

Platform Management
The Chassis Identify Push-button works using a "push-on/push-off" operation. Each
press of the push-button toggles the LED signal state between on and off. If the
pushbutton is used to turn the LED on, it will stay on indefinitely, until either the button is
pressed again or a Chassis Identify or Chassis Identify LED command causes the LED
to turn off.
Color Condition
Off
Blue
Blink
5.3.4.5 Status/Fault LED
The following table shows mapping of sensors/faults to the LED state.
Color Condition
Solid
Green
Blink
Solid
Amber
Blink
Off Solid
Critical Condition
Any critical or non-recoverable threshold crossing associated with the following events:
Temperature, voltage, or fan critical threshold crossing.
Power subsystem failure. The BMC asserts this failure whenever it detects a power
control fault (e.g., the BMC detects that the system power is remaining on even though
the BMC has deasserted the signal to turn off power to the system). A hot-swap
backplane would use the Set Fault Indication command to indicate when one or more of
the drive fault status LEDs are asserted on the hot-swap backplane.
The system is unable to power up due to incorrectly installed processor(s), or processor
incompatibility.
Satellite controller sends a critical or non-recoverable state, via the Set Fault Indication
command to the BMC.
"Critical Event Logging" errors, including: System Memory Uncorrectable ECC error and
Fatal/Uncorrectable Bus errors, such as PCI SERR and PERR.
118
Intel® Server Boards SE7320SP2 and SE7525GP2

Table 55. Chassis ID LEDs

Ok
Identify button pressed or Chassis Identify command executed

Table 56. Fault/Status LED

System Ready
System Ready, but degraded. CPU fault, DIMM killed
Critical Failure: critical fan, voltage, temperature state
Non-Critical Failure: non-critical fan, voltage, temperature state
Not Ready. POST error/NMI event/CPU or terminator missing
When
When
Revision 4.0