Intel® Workstation Board S5000XVN TPS
3.6 Super I/O
Legacy I/O support is provided by using a National Semiconductor* PC87427 Super I/O device.
This chip contains all of the necessary circuitry to support the following functions:
GPIOs
Two serial ports
Keyboard and mouse support
Wake up control
System health support
3.6.1
Serial Ports
The workstation board provides two serial ports: an external DB9 serial port and an internal
DH10 serial header. The rear DB9 serial A port is a fully-functional serial port that can support
any standard serial device.
Serial B is an optional port that is accessed through a 9-pin internal DH-10 header. A standard
DH10 to DB9 cable can be used to direct serial B to the rear of a chassis. The serial B interface
follows the standard RS232 pin-out as defined in the following table.
Pin
1
2
3
4
5
6
7
8
9
3.6.2
Floppy Disk Controller
The workstation board does not support a floppy disk controller interface. However, the system
BIOS recognizes USB floppy devices.
3.6.3
Keyboard and Mouse Support
Dual-stacked PS/2* ports are provided on the back edge of the workstation board for keyboard
and mouse support. Either port can support a mouse or keyboard. Neither port supports hot
plugging.
3.6.4
Wake-up Control
The super I/O contains functionality that allows various events to power on and power off the
system.
Revision 1.5
Table 10. Serial B Header Pin-out
Signal Name
DCD
DSR
RX
RTS
TX
CTS
DTR
RI
GND
Intel order number: D66403-006
Functional Architecture
Serial Port B Header Pin-out
31