Removing Dimms - HP D7171A - NetServer - LPr Installation Manual

Chapter 5
Figure 5-2. Inserting a DIMM into Its Socket
e. Holding the DIMM 90 degrees to the system board, press the DIMM
into the socket until the retaining clips close. If the clips do not close,
the DIMM is not inserted correctly.
CAUTION Do not rock the DIMM into its socket. Apply firm and even
pressure. It a gap exists between the retaining latches and the
DIMM, remove and replace the DIMM until no gap exists.
8. Repeat Step 2 to install all of the DIMMs for your memory configuration.
9. If you removed the system board assembly from the NetServer, replace it
now.
10. Close the system board access panel according to the instructions in
Chapter 3, Opening and Closing the HP NetServer.
11. Replace the power cords and cables.
12. Restore the NetServer to normal operation.

Removing DIMMs

You may need to remove a DIMM to downsize your memory configuration or to
replace a defective DIMM. (Refer to Figure 5-2.)
1. Log off all users, and shut down the network operating system according to
your NOS instructions.
46
DIMM
Notches
Keys
Retaining
Clip
Installing Additional Memory
Retaining
Clip