Battery - HP Xw8400 - Workstation - 4 GB RAM Technical Reference Manual

Battery

CAUTION:
CMOS settings are lost when the battery is removed. To back up the CMOS settings, use Computer
Setup and run the Save to Diskette option from the File menu.
1. Disconnect power from the system (
access panel
facing up.
2. On the system board, press on the release tab of the battery holder.
3. Rotate the battery enough to get beyond the latch, and lift it straight up.
Figure 4-45
To install the battery slide the battery back in until it snaps back into place.
ENWW
Before removing the battery, ensure your CMOS settings are backed up because all
(Access panel on page
Removing the battery
Pre-disassembly procedures on page
57). Place the workstation on its side with the system board
Removing and replacing components
50), and remove the
83