Bezel blanks
To remove the bezel blanks:
1.
Disconnect power from the system (
front bezel
2.
Remove the bezel blanks by squeezing in on the tabs (1) and pushing the bezel blanks out (2).
Figure 4-9
Hood sensor (Smart Cover Sensor)
To remove the hood sensor:
1.
Disconnect power from the system (
access panel
facing up.
2.
Disconnect the white 1 x 3 hood sensor connector from the inline connector attached to the front
panel harness.
ENWW
(Front bezel on page
Removing the bezel blanks
(Access panel on page
Pre-disassembly procedures on page
58)
Pre-disassembly procedures on page
57). Lay the workstation on its side with the system board
Removing and replacing components
50) and remove the
50) and remove the
59