2.
Disconnect the data (1), power (2) and audio (3) cables from the drive. The connector colors might
be different than illustrated.
NOTE:
Figure 4-47
3.
Lift the green drivelock release lever, and gently slide the drive out of the chassis.
Figure 4-48
To replace an optical drive:
1.
Lift the green drivelock release lever while sliding the optical drive into the bay. When the optical
drive is partially inserted, release the drivelock release lever, and slide the drive completely into
the bay until the drive is secured.
CAUTION:
when moving the workstation.
2.
Connect the power, data , and audio (if required) cables to the drive and workstation.
NOTE:
ENWW
The audio cable is only required for Linux-based systems.
Disconnecting the IDE (left) or SATA (right) cable from the optical drive
Removing the optical drive from the chassis
Ensure that the optical drive is secure. Failure to do so can cause damage to the drive
The audio cable is only required for Linux-based systems.
Removing and replacing components
85