3 Interface Cards
SCSI Adapter Cards
PCI Bus
Complies with PCI Specification 2.2.
•
Supports 64-bit, 33 MHz PCI Bus.
•
Supports PCI write and invalidate, read line and read multiple commands.
•
Functions as full 64-bit PCI DMA Bus Master.
•
Operates on 3.3 V or 5 V PCI buses.
•
Terminators
Three multi-mode SE/LVD active, auto-terminating terminators
•
Auto-termination: terminators are active when one of the tow connectors
•
is used. If both connectors are used at the same time, terminators will
automatically switch to high impedance mode.
The terminator will automatically detect the bus type (LVD or SE) and
•
switch to the right mode.
Flash memory
The flash memory stores the SCSI BIOS. Refer to the following section for
information about the Symbios SCSI Configuration Utility.
Symbios Configuration Utility (Ultra 160 Card)
The Symbios Configuration Utility lets you view and change the default
configuration for the host adapter, and all SCSI devices connected to it, or
for individual SCSI devices. If, while using this utility, you accidentally
disable all the controllers, pressing
memory test) lets you recover and configure settings.
Default Settings You Can Change
The following two tables show the configuration settings that can be
changed. The first table shows the global settings which impact the host
adapter and all SCSI devices connected to it (Adapter Properties menu).
The second table shows the device settings which apply to individual
devices (Device Properties menu).
94
during the POST (after the
Ctrl-C