HP XM600 - Kayak - 128 MB RAM Technical Reference Manual page 90

Settings for Individual SCSI
Devices
Synchronous Transfer Rate (MB/s)
Data Width
Disconnect
Read Write I/O Timeout (seconds)
Scan for Devices at Boot Time
Scan for SCSI LUNs
Queue Tags
Initial Boot Device
3 Interface Cards
SCSI Adapter Cards
Default Settings
80 Sets the transfer rate for the device. The available choices are: Off, 10 MB/sec, 20
MB/sec, 40 MB/sec, or 80 MB/sec.
16 Sets the maximum SCSI data width at which a 16-bit host adapter negotiates. The
host adapter and SCSI device must agree on a width at which they can both
operate.
For example, for a 16-bit device on a 8-bit wide cable (bus), the width at which
they can both operate is 8-bits.
Similarly, for an 8-bit device on a 16-bit wide cable (bus), the width at which they
can both operate is 8-bits.
On Enables or disables disconnects for the device.
To optimize SCSI bus performance, this option should be set to On.
This should only be set to Off for troubleshooting purposes.
10 Enters a read write time-out value in seconds for the device.
Yes Specifies whether the device is scanned for at boot time.
Yes More advanced SCSI devices can have several logical units (LUNs). This option lets
you specify whether SCSI LUNs are scanned for at boot time.
On Specifies whether queue tags are enabled or disabled. In a multi-tasking
environment this option must be set to Yes. It should only be disabled for
troubleshooting.
No This setting cannot be modified.
Starting the LSI Logic SCSI Configuration Utility
You access the LSI Logic SCSI Configuration Utility by pressing
message
Press F6 to start Configuration Utility...
during the PC Workstation's start-up routine. A further message is then
displayed:
Please wait, invoking Configuration Utility...
the Main menu of the LSI Logic SCSI Configuration utility appears.
90
Description
when the
F6
is displayed
before