Clearing The Cmos - HP XM600 - Kayak - 128 MB RAM Technical Reference Manual

Clearing the CMOS

1 Turn off the PC Workstation, disconnect the power cord and all cables,
then remove the cover.
2 Set the system board switch
3 Replace the cover, and reconnect the power cord and video cable.
4 Reboot the PC Workstation. A message similar to the following will be
displayed:
"Configuration has been cleared, set switch Clear to the
5 Turn off the PC Workstation, disconnect the power cord and video cable,
and remove the cover.
6 Set the system board switch
7 Replace the cover, and reconnect the power cord and data cables.
8 Switch on the PC Workstation. Run the Setup program by pressing
Then press , the CMOS default values will be automatically downloaded
F9
and saved.
9 Press to save the configuration and exit from the Setup program.
Esc
8 to the ON
ON position before rebooting."
8 to the OFF
Clearing the CMOS
position.
position.
5 HP BIOS
.
F2
111