Lsi Logic Scsi Configuration Utility - HP XM600 - Kayak - 128 MB RAM Technical Reference Manual

3 Interface Cards
SCSI Adapter Cards
in point-to-point connections.
Supports SCAM (SCSI Configured Automatically) Level 1 functionality.
•
PCI connector
One 32-bit universal connector (supports both 5 V and 3.3 V signaling).
•
Configured as a 7,5 W board (PRSNT1 and PRSNT2 grounded).
•
The SCSI Adapter Card sink current on the 5 V power supplies lines. The
•
3.3 V is supplied by an on-board regulator.
PCI Bus
Complies with PCI Specification 2.1.
•
Supports 32-bit, 33 MHz PCI Bus.
•
Supports PCI write and invalidate, read line and read multiple commands.
•
Functions as full 32-bit PCI DMA Bus Master.
•
Operates on 3.3 V or 5 V PCI buses.
•
Terminators
Three multi-mode SE/LVD active, auto-terminating terminators
•
Auto-termination: terminators are active when one of the two connectors
•
is used. If both connectors are used at the same time, terminators will
automatically switch to high impedance mode.
The terminator will automatically detect the bus type (LVD or SE) and
•
switch to the right mode.
Flash memory
The flash memory stores the SCSI BIOS. Refer to the following sections for
information about the LSI Logic SCSI Configuration Utility.

LSI Logic SCSI Configuration Utility

The LSI Logic SCSI Configuration Utility lets you view and change the
default configuration for the host adapter, and all SCSI devices connected to
it, or for individual SCSI devices. If, while using this utility, you accidentally
disable all the controllers, pressing
test) lets you recover and configure settings.
88
during the POST (after the memory
F6