HP T5145 - Thin Client - Tower Administrator's Manual page 62

Boot Order
●
First Boot Device: Select the first device for the thin client to boot to.
●
Second Boot Device: Select the second device for the thin client to boot to.
●
Third Boot Device: Select the third device for the thin client to boot to.
Wake-up Settings
● Wake On Lan: Select to enable wake on LAN.
●
PWRON After PWR-Fail: Select whether power is to be on/off or default to its former state after a
power failure. HP recommends setting to Former state.
● Wake Up [Sunday — Saturday]: Select to choose the day on which the thin client wakes up.
●
Wake Up Time: Click Set Time to set the time of day the thin client wakes up. You must first reboot
and then shut down the unit for this feature to work.
Configure Altiris
By default, the Altiris client is disabled. The Altiris client is automatically enabled if an Altiris server is
set up, DHCP is enabled on the Network tab, and the DHCP Altiris Server port set to 190 (or to your
unique port ID) at Settings > Management > DHCP Advanced Options. Visit
support/; in software downloads for the specific HP thin client, you can find Altiris scripts to manage the
thin client via Altiris.
●
Enable Altiris: Select to start Altiris on boot.
●
Altiris Time Sync: Select to enable time synchronization with an Altiris server, if available.
●
Use Multicast: Select if you want to use the default Altiris server address.
● Multicast Address: The default address is displayed. Type your installation address if necessary.
● Multicast Port: Type or select the Altiris server port.
● TCP Address: If Use Multicast is not selected, type the specific Altiris server address.
●
TCP Multicast Port: Type or select the Altiris server port.
56 Chapter 2 Installation
http://www.hp.com/
ENWW