HP T5145 - Thin Client - Tower Administrator's Manual page 52

NOTE:
10. Close the window.
Use the capture settings on the USB drive to replicate (deploy) on different systems or to restore the
current capture back to its original setting after settings are altered.
Deploy Captured Settings from a USB Drive
To Use HP ThinState to Deploy Captured Settings from a USB drive:
1. Attach the USB flash drive on which you captured settings.
2. On the thin client to which you want to deploy captured settings, click Settings > Management,
and click Replicate Settings by using HP ThinState.
3. Click OK on the warning message. The following window is displayed.
4. Select Deploy Settings.
5. Click Next.
6. Select the target USB flash drive from the list.
7. Click Deploy.
After image setting settings have been deployed successfully, you may remove the USB flash drive.
8. Click OK on the information message.
The thin client immediately reboots deploying settings.
NOTE:
key. Simply remove the flash drive and press any key to continue reboot.
46 Chapter 2 Installation
You must remove the USB drive prior to system reboot.
If you do not remove the USB flash drive, during reboot, you are prompted to press any
ENWW