Users In Canada - Canon D480 - ImageCLASS B/W Laser Basic Operation Manual

Legal Notices
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device,
including FAX machines, to send any message unless such message clearly contains in a margin at the top or bottom of each
transmitted page or on the fi rst page of the transmission, the date and time it is sent and an identifi cation of the business or other entity,
or other individual sending the message and the telephone number of the sending machine or such business, other entity, or individual.
(The telephone number provided may not be a 900 number or any other number for which charges exceed local or long-distance
transmission charges.)
In order to program this information into your machine, you should complete the procedure for registering your name, unit's telephone
number, time, and date in the Starter Guide.

Users in Canada

Users in Canada
Pre-Installation Requirements for Canon Facsimile Equipment
A. Location
Supply a suitable table, cabinet, or desk for the machine. See Chapter 13, "Appendix," for specific
dimensions and weight.
B. Order Information
1. A single telephone line (touch-tone or rotary) should be used.
2. Order a CA11A modular jack, which should be installed by the telephone company. If the CA11A jack
is not present, installation cannot occur.
3. Order a normal business line from your telephone company's business representative. The line
should be a regular voice grade line or an equivalent one. Use one line per unit.
DDD (Direct Distance Dial) line
-or-
IDDD (International Direct Distance Dial) line if you communicate overseas
Canon recommends an individual line following industry standards, i.e., 2,500 (touch-tone) or 500 (rotary/pulse dial) telephones. A
dedicated extension off a PBX (Private Branch eXchange) unit without "Call Waiting" can be used with your facsimile unit. Key telephone
systems are not recommended because they send nonstandard signals to individual telephones for ringing and special codes, which
may cause a facsimile error.
C. Power Requirements
The power outlet should be a three-prong grounded receptacle (Single or Duplex). It should be
independent from copiers, heaters, air conditioners, or any electric equipment that is thermostatically
controlled. The rated value is 115 volts and 15 amperes. The CA11A modular jack should be relatively
close to the power outlet to facilitate installation.
xxii