When Paper Or An Original Jams; Jam Location Display; Cautions; Removal Procedure - Kyocera KM-4850w Operation Manual

6. When Paper or an Original Jams

When paper or an original jams, copying will stop and a message indicating a jam will appear. Keep the main power switch on ( ) and remove the
jammed paper in accordance with the message.

(1) Jam location display

1
2
3
1 Jam in the machine
2 Jam in the bypass slot (Page 8-11)
3 Jam in the paper feed section (Page 8-11)
Jam in the original cover (Page 8-13)

(2) Cautions

WARNING
High voltage is present in the charger section. Take sufficient
care when working in this area, as there is a danger of
electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take sufficient care
when working in this area, as there is a danger of getting
burned.
• Do not reuse any paper that has jammed.
• If the jammed paper tears during removal, make sure not to leave
any pieces inside the machine as this would cause another jam.
• After removal of jammed paper or original, warm up will begin, the
message will go out, and the machine will return to the settings
before the jam has occurred.
CHAPTER 8 TROUBLESHOOTING

(3) Removal procedure

1 If "Paper misfeed. Press "Cut paper" key." or "Paper misfeed. Pull
out original table. " appears:
Paper has jammed in the machine. Perform the following procedure
to remove the jammed paper.
(Inch)
(Metric)
(Inch)
(Metric)
1
If "Press "Cut paper" key." appears, press the Roll Cut key.
IMPORTANT
• Do not open any cover before pressing the Roll Cut key.
8-9