Kyocera KM-4850w Operation Manual page 99

TROUBLE
Copy image is shifted to the
original insertion side or the
opposite side.
Copy paper length is different
from the specified length.
Copies are wrinkled or curled.
Toner does not adhere well to
the copy paper.
Copy film is sticky.
Copy film is wavy.
The dimensions of the copy
image do not fit the dimensions
of the original.
CHECK POINT
Was the margin copy set?
Was the image shift function
set?
Was the margin copy set?
Is the paper material setting
correct?
Is the paper wet?
Is the roll unit flange set
properly?
Is the fixing temperature
proper?
Is the paper material setting
correct?
Was thick paper used?
Is film selected as a paper
material?
Is film selected as a paper
material?
Is the fixing temperature
proper?
Is the paper material setting
correct?
Was the copy size adjusted?
CHAPTER 8 TROUBLESHOOTING
PROCEDURE
Cancel the margin copy.
Cancel the image shift function.
Cancel the margin copy.
Press the Media key to select the correct paper
material.
Replace the paper roll with a new one. Depending
on the operating environment, turn the dew
prevention heater switch on.
Set the roll unit flange properly.
Adjust the fixing temperature to a lower temperature.
Press the Media key to select the correct paper
material.
Adjust the fixing temperature to a higher tempera-
ture.
Press the Media key to select film.
Press the Media key to select film.
Adjust the fixing temperature to a lower temperature.
Press the Media key to select the proper paper
material.
Adjust the copy size.
PAGE
5-7
5-5
5-7
4-5
3-7
3-6
7-2
4-5
7-2
4-5
4-5
7-2
4-5
7-2
8-15