Deleting Image Data - Kyocera KM-4850w Operation Manual

3
If only the number of copies is to be changed, press the
key to select "Additional copy".
To change copy settings, press the
"AMS mode for all originals".
(Inch)
(Metric)
4
Press the OK key.
• If "Additional copy" has been selected, proceed to the next
step.
• If "AMS mode for all originals" has been selected, proceed
to step 6.
5
Use the numeric keys to enter the number of copies.
Proceed to step 7.
(Inch)
(Metric)
6
Change copy settings.
(Inch)
(Metric)
or
or key to select
CHAPTER 6 CONVENIENT FUNCTIONS
7
Press the Start key. Copying will start.

(3) Deleting Image Data

If the Reset key is pressed when repeat copy has been set, the image
data in memory will be deleted.
To prevent image data from being deleted by mistake, a confirmation
screen for image deletion can be displayed. Set "^ Delete memory"
of the default setting to "Confirm before deleting" ["Check data of
repeat copy"]. (Page 7-6) If "Confirm before deleting" ["Check data of
repeat copy"] is set, when the Reset key is pressed after repeat copy
has been set, the confirmation screen shown below will appear.
(Inch)
(Metric)
1 Press the
or key to select a choice.
If "Cancel repeat copy(delete)" is selected, the image data will be
deleted and the machine will return to the initial state.
If "Continue repeat copy" is selected, copy settings will be cleared
but image data will not be cleared.
2 Press the OK key.
6-5