Kyocera KM-4850w Operation Manual page 86

CHAPTER 8 TROUBLESHOOTING
Message
"No roll unit" ["Roll unit is not set."]
"Add Paper in X Drawer."
"Check waste toner tank."
"Add toner."
"Time for Maintenance"
"Call service."
"Memory full"
"Could not be saved."
"Exceeding zoom range. Reenter zoom ratio."
"These functions cannot be combined."
"Incorrect pin code." ["Incorrect ID-Code."]
"Repeat copy code is wrong."
"Insert key counter."
8-2
Countermeasures
A roll unit is not securely inserted. Open the front cover and
push the roll unit in securely.
Paper with different width is set for interrupt copy or job
reserve. Replace the paper roll.
The waste toner tank is full or the tank is not properly installed.
Replace it with a new tank or install the tank properly.
If this message is displayed with "Ready to copy.", copying can
be performed but continuous copying is not possible. Replen-
ish toner promptly. Copying can be performed for some time
but when only this message is displayed, copying cannot be
performed.
Maintenance of the machine is needed. Contact your service
representative.
A problem has occurred inside the main body. See
"5. Countermeasures against Call for service Message".
Memory overflow has occurred. See "4. Countermeasures
against Memory Overflow."
Original images cannot be saved in memory. Copying of
second original and after or repeat copy cannot be performed.
See "4. Countermeasures against Memory Overflow."
The magnification ratio or another setting for editing functions
exceeds the specified limit. Press the OK key and then enter
the value again.
A function or a default setting that cannot be set now is
accessed. See "List of Default Setting".
The password is not correct. Use the numeric keys to enter the
correct password.
The repeat copy code is not correct. Use the numeric keys to
enter the correct code.
The key counter (option) is not set or not properly set. Set the
counter properly.
Page
3-6
3-6
8-5
8-3
–
8-8
8-6
8-6
–
7-1
7-3
7-6
4-1