Selecting A Finishing Setting; Automatic "Sort"/"Non-Sort" Setting Selection - Kyocera KM-C2030 Operation Manual

5.2 Selecting a Finishing Setting

5.2 Selecting a Finishing Setting
Various settings for sorting and finishing copies are available.
Tip
The Finishing settings can be used together with other functions. For details, re-
fer to the "Function Combination Table" in the Administrator Operations volume.
The following eight ways of finishing are available.
G Non-sorting ("Non-Sort" setting)
G
Crisscross non-sorting ("Non-Sort" setting)
G
Sorting ("Sort" setting)
G
Crisscross sorting ("Sort" setting)
G Stapling (Corner Staple)
G
Stapling (2-Point Staple)
G Hole-punching (2-Hole punch)
G Hole-punching (3-Hole punch)
Note
Crisscross non-sorting and crisscross sorting are only available if the finisher is
not installed.

Automatic "Sort"/"Non-Sort" Setting Selection

When a document is loaded into the duplexing document feeder, the "Non-Sort"
setting is automatically selected if the document consists of only one page, and the
"Sort" setting is automatically selected if the document consists of 2 or more pages.
Whether or not the "Sort" or "Non-Sort" setting is automatically selected can be
specified using the "Intelligent Sorting" function on the User's Choice: 2 screen. For
more details, refer to "Specifying Default Settings ("User's Choice" Functions)" of
"Utility Mode Operations" in the Administrator Operations volume.
5
5-3