Stapling (With Finisher Df-620 Installed); Stapling (With Finisher Df-625 Installed); Hole-Punching - Kyocera KM-C2030 Operation Manual

5.2 Selecting a Finishing Setting
❍
For details on the "User's Choice" functions, refer to "Specifying Default Set-
tings ("User's Choice" Functions)" in the Administrator Operations volume.

Stapling (with finisher DF-620 installed)

The copies are bound together with a staple in the corner.
However, stapling is only performed if the following conditions are met.
G
The number of copies is set to between 2 and 30.
G If standard-size paper is used, the paper sizes must be Letter L, Letter C, Exec-
utive L (7-1/4 × 10-1/2 in. L), Executive C (7-1/4 × 10-1/2 in. C), Legal L and
11 × 17 L.
G If nonstandard-size paper is used, the paper width must be between 7-1/4 in.
and 11-3/4 in.
G If nonstandard-size paper is used, the paper length must be between 7-1/4 in.
and 17 in.
G
The copier must not enter Interrupt mode.

Stapling (with finisher DF-625 installed)

The copies are bound together with a staple. Either the "Corner Staple" or the "2-
Point Staple" Finishing setting can be selected.
However, stapling is only performed if the following conditions are met.
G The number of copies is set to between 2 and 50. (However, if the paper length
is 11-3/4 in. or more, the number of copies can only be set to 25 or less.)
G If standard-size paper is used, the paper sizes must be Letter L, Letter C,
Legal L and 11 × 17 L.
G If nonstandard-size paper is used, the paper width must be between 7-1/4 in.
and 11-3/4 in.
G If nonstandard-size paper is used, the paper length must be between 7-1/4 in.
and 17 in.
G The copier must not enter Interrupt mode.

Hole-Punching

Two holes for filing copies in binders can be punched. The position of the punched
holes can be specified along the left side or along the top.
However, hole-punching is only performed if the following conditions are met.
G Finisher DF-625 is installed.
G
Punch kit PH-620 is installed.
G If standard-size paper is used, the paper sizes must be as follows:
Letter L, Letter C, Legal L and 11 × 17 L (with the "2-Hole Punch" setting)
Letter C and 11 × 17 L (with the "3-Hole Punch" setting).
G
If nonstandard-size paper is used, the paper width must be between 7-1/4 in.
and 11-3/4 in.
5
5-5