Finishing Edge Combinations; Setting The Finishing Edge; Positioning Options For Finishing Edge; Custom Finishing Edge Settings - Kyocera TASKalfa 420i User Manual

Finishing

Finishing Edge Combinations

Setting the Finishing Edge

1
2
3
4
5
6
7

Positioning Options for Finishing Edge

Custom Finishing Edge Settings

6-2
Selecting Finishing edge makes some other features unavailable, such as
Separation and Rotated. Finishing edge cannot be used with the Poster
feature.
Finishing edge can be used with the following page size combinations:
A4 and A3 (210 x 297 mm and 297 x 420 mm)
B5 (JIS) and B4 (182 x 257 mm and 257 x 364 mm)
Letter and Legal (8.5 x 11 in. and 8.5 x 14 in.)
Letter and Ledger (8.5 x 11 in. and 11 x 17 in.)
In the Basic tab, set Print size and Page size to the same size.
In the Basic tab, in the Source list select an Auto source.
In the Finishing tab, select Finishing edge.
Select from available Position options, or select Custom. Positions are based
on the Print size selection in the Basic tab.
Click OK in all driver dialog boxes.
Load each paper size into different paper cassettes. For example, load A4 and
A3 paper so that both sizes feed the 297 mm edge or load letter and legal paper
so that both sizes feed the 8.5 inch edge.
Click OK in the application's Print dialog box.
If the printer driver determines that the specified paper size or direction (short or
long edge) is not available in the printing system, the operation panel message
requests that you load the correct paper size into the cassette with the correct
orientation.
You can select from available options to specify the page edges to be aligned
and finished. For additional position settings, select Custom, then click
Settings. Available options for Position depend on Print size, Orientation,
Booklet, and Multiple pages per sheet selections.
In the side panel display, the page image shows a blue highlighted strip to
indicate the current selected Finishing edge and Staple positions, if selected.
When the Staple option is used, the Position selection determines where
staples are placed. Use this image to verify your selections for Finishing edge
and Staple.
To select Custom for Position, click Settings to open the Custom Finishing
Edge Settings dialog box. Select one of the settings. The illustrations in the
dialog box help you visualize the page alignments.
User Guide