2.6.
Full Cutter Adjustment Mode ( " F " key )
This mode adjusts the location of the full cutter.
(1)
Press the "F" key while the LCD displays as shown in Fig.19. The display shifts to the
Full Cutter Adjustment Mode as shown if Fig. 20.
(2)
Press the "RET" key. The display shifts as shown in Fig.21.
(3)
Press the "F" key. The display shifts to the Full Cut Blade Length Adjustment Mode.
(4)
Use the numeric keys to enter the differential from the half cut step numbers and the
step length.
(5)
Press the "RET" key to write the above entries into the EEPROM. The machine
execute three lines of full cut operation forward and backward around the central step
number according to the specified step length as shown in Fig.22. After printing, the
display returns as shown in Fig 21 that enables to select the initial items.
Note: If you accept the default settings, press the "RET" key to start the sample
printing.
(Example: Half cut is 180 and step length is fixed to 15)
(6)
Press the "G" key while the LCD displays as shown in Fig.20. The display shifts to the
Tape Control Motor Excitation-Phase Check Mode as shown if Fig. 23.
Fig. 19
Fig. 20
Fig. 21
Fig. 22
III-65