Brother PT-9600 Service Manual page 67

(2) Insert the diode (SLR-342MC) in the LCD holder and solder it to the LCD PCB ASSY (PT-
9600 only).
Note: Do not mix up the plus and minus pins of the diode. The longer pin is for "plus" while
the shorter pin is "minus".
(3) Insert the LED PCB ASSY into the hooks "B" in two places of the LCD holder (PT-9600
only).
(4) Pass the leads (three harnesses) of the LED PCB ASSY through the slot of the LCD holder
and solder it to the LCD PCB ASSY (PT-9600 only).
Note: Solder the leads (three harnesses) to the LCD PCB ASSY in accordance with the
color indications on the LCD substrate.
LED PCB ASSY
LCD holder
LCD PCB ASSY
(5) Reassemble the light plate ASSY to the LCD module unit fixing with the hooks in three
places.
LCD module unit
Diode
Hole
Hook "B"
Fig. 3.2-7 Reassembling the LCD Module Unit (2)
Hook "A"
Fig. 3.2-8 Reassembling the LCD Module Unit (3)
Hook "B"
III-33
LCD PCB ASSY
Leads (three harnesses)
Light plate ASSY
Hook "A"