Brother PT-9600 Service Manual page 94

* Specification Change Mode : " 1 " key
* AC Adapter Rank Adjustment Mode : " 2 " key
* Sensor Check Mode : " 3 " key
* LCD Display Check Mode : " 4 " key
* Half Cutter Adjustment Mode : " 5 " key
* Key Inspection Mode : " 6 " key
* Print Mode 1 : " 7 " key
* Avery Detection Voltage Mode : " 8 " key
* Avery Print Mode : " 9 " key
* RS I/F Port Check Mode : " 0 " key
* Clock Display Mode : " Q " key
* Charge Check Mode : " W " key
* Avery Control Value Display Mode : " E " key
* Margin Set Mode : " R " key
* USB Mode : " A " key
* Full Cutter Adjustment Mode : " F " key
* Tape Control Motor Excitation-Phase Check Mode: " G " key
2.1. Specification Change Mode ( " 1 " key )
This mode determines a country unique specification.
(1) Press the "RET" key while the LCD displays as shown in Fig. 2. The display shifts to
the Specification Change Mode as shown in Fig. 3.
(2) Press the "RET" key. The display shifts to one as shown in Fig.4.
(3) Select a country by pressing the number key (1 through 5).
(4) The machine writes the country setting into the EEPROM when the "RET" key is
pressed and also shifts to the AC Adapter Rank Adjustment Mode as shown in Fig. 5.
Fig. 3
Fig. 4
III-60