Brother PT-9600 Service Manual page 108

(2) If you want to set a minus correction value, correct the current value according to one
of the following key operations. The result will be displayed as shown in Fig.50.
To move the print start position by the following amount:
The correction value is displayed as "±0 mm".
to the left side by approx. 0.5 mm (7 dots).
to the left side by approx. 1.0 mm (14 dots).
to the left side by approx. 1.5 mm (21 dots).
to the left side by approx. 2.0 mm (28 dots).
to the left side by approx. 2.5 mm (35 dots).
to the left side by approx. 3.0 mm (43 dots).
to the left side by approx. 3.5 mm (50dots).
to the left side by approx. 4.0mm (57 dots).
to the left side by approx. 4.5 mm (64 dots).
(Example: Corrects by about 1.0 mm to the left side)
(3) If you want to set a plus correction value, correct the current value according to one of
the following key operations. The result will be displayed as shown in Fig.51.
To move the print start position by the following amount:
The correction value is displayed as "±0 mm".
to the right side byYapprox. 0.5 mm (7 dots).
to the right side by approx. 1.0 mm (14 dots).
to the right side by approx. 1.5 mm (21 dots).
to the right side by approx. 2.0 mm (28 dots).
to the right side by approx. 2.5 mm (35 dots).
to the right side by approx. 3.0 mm (43 dots).
to the right side by approx. 3.5 mm (50dots).
to the right side by approx. 4.0mm (57 dots).
to the right side by approx. 4.5 mm (64 dots).
(Example: Corrects by about 1.0 mm to the right side)
Fig. 50
Fig. 51
III-74
Press:
" "+ "0" key
" "+ "1" key
" "+ "2" key
" "+ "3" key
" "+ "4" key
" "+ "5" key
" "+ "6" key
" "+ "7" key
" "+ "8" key
" "+ "9" key
Press:
" "+ "0" key
" "+ "1" key
" "+ "2" key
" "+ "3" key
" "+ "4" key
" "+ "5" key
" "+ "6" key
" "+ "7" key
" "+ "8" key
" "+ "9" key