Brother PT-9600 Service Manual page 79

Reassembling the Eject Unit
(1) Assemble the eject gear on the eject roller shaft.
(2) Assemble the eject rubber on the eject roller shaft.
(3) Assemble the eject roller ASSY on the tape guide.
Note: Apply the silicon grease (Shin-Etsu Chemical brand G501) by a quarter rice-grain
sized drop to the both tips of the eject roller shaft. Make sure not to apply the silicon
grease to the eject rubber.
Apply grease.
Eject roller ASSY
Apply grease.
Eject rubber
Eject roller shaft
Eject gear
Fig. 3.2-27 Reassembling the Eject Unit (1)
Fig. 3.2-28 Reassembling the Eject Unit (2)
III-45
Tape guide