(5)
Press the "2" key. The display shifts to the Print Mode 2 that enables to set and print
the sample print to examine the cutter blade length.
(6)
Use the numeric keys to enter the central step number for cutting and the step numbers
forward and backward by the specified step interval from the central step number for
cutting examination.
(7)
Press the "RET" key to fix the above entries. The machine starts the sample printing.
Three lines of half cut operation are executed forward and backward according to the
specified step length as shown in Fig.17. After printing, the display returns as shown in
Fig 15 that enables to select the initial items.
Note 3: Press only the "RET" key to start the sample printing, if you accept the default
setting values.
(Example: Step 185 ± 5 is specified)
(8)
Press the "3" key. The display shifts to the Half Cut Blade Length Adjustment Mode.
(9)
Use the numeric keys to enter the central step number and the step length.
(10) Press the "RET" key to write the above entries into the EEPROM. The machine
execute three lines of half cut operation forward and backward around the central step
number according to the specified step length as shown in Fig.18. After printing, the
display returns as shown in Fig 15 that enables to select the initial items.
Note 4: Prease only the "RET" key to sent the sample printing, if you accept the default
setting values.
(Example: Step 180 ± 1 is specified)
(11) Press the "RET" key while the LCD displays as shown in Fig.15. The display shifts to
the Key Check Mode as shown in Fig.19.
Note 5: You must enter the Full Cutter Adjustment Mode and the Tape Control Motor
Excitation-Phase Check Mode after the replacement of the main PCB or the
parts of the cutter mechanism.
Fig. 17
Fig. 18
III-64