Brother PT-9600 Service Manual page 103

2.9. Print Mode 1 ( " 7 " key )
This mode verifies the print quality and the print accuracy.
(1) Press the "RET" key to start to print. After the completion of printing, this mode shifts
to the Avery Detection Voltage Mode as shown in Fig.34.
Note: If the AC Adapter Rank Adjustment Mode and the Half Cutter Adjustment Mode
were not completed (i.e., setting values had not been written in the EEPROM),
the machine does not start to print.
(2) Verify the print quality and the print accuracy of the print sample.
2.10. Avery Detection Voltage Mode ( " 8 " key )
This mode reads the detection mark of the avery cassette and the reference voltage level of
it, and writes the voltage level into the EEPROM of the main PCB.
Note 1: This mode is used only for PT-9600 and PT-3600 (U.S.A. version).
Note 2: Make sure to use an address labels cassette. Do not use any types of cassettes
other than the avery cassette.
Fig. 33
69.2±3.5mm
Print Sample 1
Fig. 34
III-69