Sampled Audio For Sound Effects <Sampled_Audio - Polycom SoundPoint IP 601 Administrator's Manual

Administrator Guide - SoundPoint
In the following table, x is the chord-set number and cat is one of callProg,
ringer, or misc.
Attribute
tone.chord.cat.x.freq.y
tone.chord.cat.x.level.y
tone.chord.cat.x.onDur
tone.chord.cat.x.offDur
tone.chord.cat.x.repeat
4.6.1.6 Sampled Audio for Sound Effects <sampled_audio/>
The following sampled audio WAVE file (.wav) formats are supported:
• mono 8 kHz G.711 µ-Law
• G.711 A-Law
• L16/16000
The phone uses built-in wave files for some sound effects. The built-in wave files can
be replaced with files downloaded from the boot server or from the Internet, however,
these are stored in volatile memory so the files will need to remain accessible should
the phone need to be rebooted. Files will be truncated to a maximum size of 300 kilo-
bytes.
8. L16/16000 is not supported on SoundPoint
® ®
IP / SoundStation IP
Permitted
Values
0-1600
-57 to 3
positive
integer
positive
integer
positive
integer
8
(16-bit, 16 kHz sampling rate, mono)
®
IP 300, 301 and SoundStation
Copyright © 2005 Polycom, Inc.
Interpretation
Frequency for this component in Hertz; up to four
chord-set components can be specified (y=1, 2, 3,
4).
Level of this component in dBm0.
On duration in milliseconds, 0=infinite.
Off duration in milliseconds, 0=infinite.
Specifies how many times the ON/OFF cadence
is repeated, 0=infinite.
®
IP 4000 phones.
Optimization
85