Ieee 802.1P/Q - Polycom SoundPoint IP 601 Administrator's Manual

Administrator Guide - SoundPoint
be set to a value from 0 through 7. The type of service can be configured specifically
for RTP packets and call control packets, such as SIP signaling packets.
Central
(boot
server)
Local

4.5.2 IEEE 802.1p/Q

The phone will tag all Ethernet packets it transmits with
The 802.1p/Q user_priority field can be set to a value from 0 to 7. The user_priority
can be configured specifically for RTP packets and call control packets, such as SIP
signaling packets, with default settings configurable for all other packets.
Central
(boot
server)
Local
68
®
IP / SoundStation
Configuration file:
sip.cfg
Web Server
(if enabled)
Local Phone User
Interface
1. when it has a valid VLAN ID set in its network configuration, or
2. is instructed to tag packets via Cisco Discovery Protocol (CDP) running on
a connected Ethernet switch, or
3. a VLAN ID is obtained from DHCP (see 2.2.1.3.2 DHCP Menu on page 8).
Configuration file:
sip.cfg
Web Server
(if enabled)
Local Phone User
Interface
Copyright © 2005 Polycom, Inc.
®
IP
Specify protocol-specific IP TOS settings.
• For more information, see 4.6.1.9.2 IP TOS <IP/> on
page 103.
Specify IP TOS settings.
Navigate to: http://<phoneIPAddress>/netConf.htm#qo
None.
Specify default and protocol-specific 802.1p/Q settings.
• For more information, see 4.6.1.9.1 Ethernet IEEE
802.1p/Q <Ethernet/> on page 102.
Specify 802.1p/Q settings.
Navigate to http://<phoneIPAddress>/netConf.htm#qo
Specify whether CDP is to be used or manually set the VLAN
ID or configure DHCP VLAN Discovery.
Phase 1: bootRom - Navigate to: SETUP menu during auto-
boot countdown.
Phase 2: Application - Navigate to: Menu>Set-
tings>Advanced>Admin Settings>Network Configuration
• For more information, see 2.2.1 Basic Network Setup on
page 4.
Optimization
an 802.1Q VLAN header
: