Checking The Input Sensor And Dip Switch Input - Brother BAS-343E Instruction Manual

9. Standard adjustments

9-13. Checking the input sensor and DIP switch input

PROGRAM NO. PROGRAM NO.
u
R / W
e
1. When the SPLIT NO. indicator q is illuminated and the R/W switch e is pressed while the TEST switch w is being
pressed, the X-SCALE indicator r will illuminate and the state of the X home position signal will appear on the
display screen t.
When sensor is ON
2. Each time the MENU switch y is pressed, a different indicator will illuminate and the operating condition for the
corresponding item will appear on the display screen.
• When X-SCALE indicator is illuminated
• When Y-SCALE indicator is illuminated
• When SPEED indicator is illuminated
• When B.T. COUNTER indicator is illuminated
• When SPLIT ON. indicator is illuminated
3. If the settings for DIP switch A at the side of the operation panel are changed at this time, the number of the
changed switch will appear in the top row of the program number display u.
4. If the settings for DIP switch B are changed at this time, the number of the changed switch will appear in the
bottom row of the program number display u.
40
BAS-300E series
MENU
r
X - SCALE
Y - SCALE
SPEED
B.T. COUNTER
q
SPLIT N .
y\
t
B.T. SET B. B.T. CHANGE . CHANGE
TEST
STEP BACK
w\
When sensor is OFF
: X home position sensor
: Y home position sensor
: Needle up signal (synchronizer)
: 24-section signal (synchronizer)
: Needle down signal (synchronizer)
BAS-343E
A
POWER
B
OFF
OFF