Checking The Input Sensor And Dip Switch Input - Brother BAS-311E Service Manual

Chapter 6 Power supply and electrical parts adjustment
Possible setting
SW No.
memo-3A
memo-3B -
memo-3F

7. Checking the input sensor and DIP switch input

PROGRAM NO. PROGRAM NO.
u
R / W
e
1. When the SPLIT NO. indicator q is lit and the R/W switch e is pressed while the TEST switch w is being pressed, the
X-SCALE indicator r will be lit and the state of the X home position signal will appear on the display t.
When sensor is ON
When sensor is OFF
2. Each time the MENU switch y is pressed, a different indicator will illuminate and the operating condition for the
corresponding item will appear on the display.
¡When X-SCALE indicator is lit
¡When Y-SCALE indicator is lit
¡When SPEED indicator is lit
¡When B.T. COUNTER indicator is lit
¡When SPLIT ON. indicator is lit
3. If the settings for DIP switch A at the side of the operation panel are changed at this time, the changed switch number
will appear in the left digit of the PROGRAM NO. display u.
4. If the settings for DIP switch B are changed at this time, the changed switch number will appear in the right digit of the
PROGRAM NO. display u.
90
Initial
Units
range value
1-3 ----
---- ----
BAS-300E series
MENU
r
X - SCALE
Y - SCALE
SPEED
B.T. COUNTER
q
SPLIT N .
y\
: X home position sensor
: Y home position sensor
: Needle up signal (synchronizer)
: 24-split signal (synchronizer)
: Needle down signal (synchronizer)
BAS-311E.311EL.326E.326EL
2
Change speed limit by stitch length.
(Max. speed remains same)
1:Speed limit by stitch length is up,sewing speed increases.
2:Standard
3:Speed limit by stitch length is down, sewing speed
decreases.
* In case drifting problem occurs at a part of large stitch
length, select 3.
* If you select 1, Please be careful because drifting might
occur depending on sewing condition.
0
t
B.T. SET B.T. CHANGE
TEST
STEP BACK STEP BACK
w\
Explanation
----
A
POWER
. CHANGE
B
Ï
OFF
OFF